Canon BP-511 - Manual (Page 22)

22
1 Connect the power cord.
● Connect the power cord to the compact
power adapter.
● Insert the plug into a power outlet.
2 Remove the cover.
● Store the cover in a place where it will not
be lost.
● If you remove the battery from the camera,
be sure to reattach the cover to protect
against short circuit.
3 Place the battery in the adapter.
● Align the end of the battery with the < – >
mark on the adapter, press down on the
battery, and slide it into place.
● To remove the battery, use the reverse of
the above.
● Batteries can be charged in either the left or
right side of the adapter.
4 Charge the battery pack.
➡ As soon as you place the battery pack in
the compact power adapter, the charge
lamp starts blinking and charging begins.
➡ When charging is complete, the lamp stops
blinking and stays on.
➡ It can take up to 90 minutes to fully
charge a battery pack.
● You can check whether a battery is charged
by seeing whether the charge lamp blinks
or stays on.
➡ When charging is complete, the charge
lamp stops blinking and stays on. You can
continue charging the battery for approxi-
mately an hour to reach full charge
capacity.
● When charging is complete, remove the
battery and unplug the power cord from the
outlet.
Charging the Battery Pack
Battery charge
0–50%
50–75%
Over 75%
Almost full
Charge lamp
Blinks once per
second
Blinks twice per
second
Blinks three times
per second
Stays on
< – > mark