Dell POWEREDGE M1000E - Manual (Page 12)

Software User’s Manual Rev 1.00
12
3 Command Line Interface (CLI) Reference
10GbE PTM management is done via the 10GbE PTM CLI. You can use the commands described
in this section after successfully connecting to the 10GbE PTM CLI according to the procedure
described in
Section 2, “Connecting to the 10GbE PTM CLI,” on page 8 .
3.1 Quick Reference
Table 5 provides a quick reference to the CLI commands:
3.2 CLI Command Reference Conventions
This section describes the PTM CLI commands.
For each command, the following information is provided:
• Synopsys:
Lists the command name and any required or optional parameters. Variable parameters (like port
numbers) are shown in italics. Optional parameters are shown in square brackets, e.g.
[optional_parameter]. Required parameters are shown with no brackets.
• Description:
Provides a detailed description of the command and of all its parameters
Table 5 - List of Commands
Command
name
Short Description Reference
General Commands
help Shows the list of available commands Section 3.3.1, “help,” on page 13
exit Exit current privilege level Section 3.3.2, “exit,” on page 13
Software Image Commands
show image ver Shows the software image version Section 3.4.1, “show image ver,” on
page 13
copy image from-
file Upload new software image to the PTM Section 3.4.2, “copy image from-file,”
on page 14
Port Commands
show port link Shows port link state Section 3.5.1, “show port link,” on
page 15
show port module Shows uplink module parameters Section 3.5.2, “show port module,” on
page 16