Dell Vostro 500 (Mid 2009) - Manual (Page 109)

Adding and Replacing Parts
109
NOTICE:
To help prevent damage to the system board, you must remove the battery
from the battery bay before you service the computer.
NOTE:
To avoid damage to the computer, use only the battery designed for this
particular Dell computer. Do not use batteries designed for other Dell computers.
5 Turn the computer over.
6 Slide the battery release latch toward the side of the computer until it
is engaged.
7 Slide the battery out of the battery bay.
8 Turn the computer top-side up, open the display, and press the power
button to ground the system board.
9 Remove any installed cards from the ExpressCard slot (see "Removing an
ExpressCard or Blank" on page 63) and the 8-in-1 memory card reader (see
"Removing a Memory Card or Blank" on page 65).
Hard Drive
CAUTION:
If you remove the hard drive from the computer when the drive is hot,
do not touch the metal housing of the hard drive.
CAUTION:
Before you begin any of the procedures in this section, follow the
safety instructions in the Product Information Guide.
1 battery 2 battery release latch
2 1
book.book Page 109 Thursday, August 7, 2008 5:00 PM