Display assembly, Removing the display assembly – Dell Latitude D410 User Manual
Page 11
Back to Contents Page
Display Assembly
Dell™ Latitude™ D410 Service Manual
Replacing the Display Assembly
Removing the Display Assembly
1.
Follow the instructions in "
Preparing to Work Inside the Computer
."
2.
Turn the computer over and remove the two M3 x 5-mm screws labeled "D" from the computer base.
3.
Turn the computer over top side up and open the display approximately 180 degrees so that it lies flat against your work surface.
4.
Remove the
center control cover
.
5.
Remove the
keyboard
.
6.
Remove the metal shield:
a.
Loosen the two captive screws that secure the metal shield.
b.
Lift the shield on the side near the screw hole, slide the shield tabs out from under the edge of the computer base, and lay the shield aside.
7.
Disconnect the antenna cables from the Mini PCI card and re-route the cables so that they are clear of the computer base.
CAUTION:
Before you begin any of the procedures in this section, follow the safety instructions located in the Product Information Guide.
NOTICE:
To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal surface (such
as the back panel) on the computer.
NOTICE:
You must remove the display assembly before you remove the palm rest.
1 M3 x 5-mm screws (2)