Dell Latitude D410 - Manual (Page 6)

Back to Contents Page
Internal Card With Bluetooth® Wireless Technology
Dell™ Latitude™ D410 Service Manual
Removing the Internal Card With Bluetooth® Wireless Technology
Replacing the Internal Card With Bluetooth® Wireless Technology
Removing the Internal Card With Bluetooth® Wireless Technology
1. Follow the instructions in " Preparing to Work Inside the Computer ."
2. Remove the battery .
3. Remove the door for the internal card with Bluetooth® wireless technology:
a. Loosen the captive screw on the card door.
b. Lift out the card door.
4. Remove the M2 x 3-mm card screw.
5. Using a plastic scribe or screwdriver, gently pry the card from its compartment and lift out the card from underneath the captive-screw hole.
6. Holding the card with one hand, use your other hand to gently disconnect the card from the card connector, and remove the card from the computer.
Replacing the Internal Card With Bluetooth® Wireless Technology
1. Holding the internal card with Bluetooth® wireless technology with one hand, use your other hand to gently connect the card connector to the card, and
insert it into the computer.
2. Replace the card door.
CAUTION: Before performing the following procedures, read the safety instructions in your Product Information Guide.
NOTICE: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal surface (such
as the back panel) on the computer.
1 door for internal card with Bluetooth® wireless technology
2 captive screw on card door
3 card connector
4 internal card with Bluetooth® wireless technology
5 M2 x 3-mm screw