Dell PowerVault TL4000 - Manual (Page 19)

Configuring the iSCSI bridge
Dell Model TL24iSCSIxSAS 1Gb iSCSI to SAS User’s Guide Rev.C Page 17
7. Configuring the iSCSI bridge
Before the iSCSI bridge can be used on the network for the first time, it is necessary to configure a number
of IP parameters. To make this as easy as possible, the iSCSI bridge has a Graphical User Interface (GUI)
that can be accessed via any web browser.
7.1 Initial set up
Connect the iSCSI bridge to the Dell PowerVault drives and the network as described in the previous
sections and power up the unit.
From your web browser, connect to the iSCSI bridge using the IP-address 10.10.10.10
Depending on how the network parameters are set on the machine you are using to access the iSCSI
bridge, it may be necessary to change your network setting on your computer for the initial set up (see
Appendix A and B for further help).
Once you have connected to the GUI you will see the entry page shown below.
Figure 13 Login page
Enter the default password – admin. If the password is entered incorrectly, the following screen will be
displayed.