Dell PowerEdge RAID Controller 5i - Manual (Page 28)

26
Hardware Installation and Configuration
Figure 3-1. Installing a PERC 5/E Adapter
7 Tighten the bracket screw, if any, or use the system’s retention clips to secure the controller to the
system’s chassis.
8 Replace the cover of the system. See your system’s Hardware Owner’s Manual for more information on
closing the system.
9 Connect the cable from the external enclosure to the controller. See Figure 3-2.
Figure 3-2. Connecting the Cable From the External Enclosure
10 Reconnect the power cable(s) and network cables, and then turn on the system.
filler bracket
PCI-E slot
PERC 5/E Adapter
bracket screw
cable from the
external enclosure
system
connector on the
controller
Dell_PERC5_UG.book Page 26 Tuesday, February 13, 2007 6:02 PM