Dell PowerEdge RAID Controller 5i - Manual (Page 37)

Hardware Installation and Configuration
35
Figure 3-9. Connecting Cables to the Controller
9 Replace the cover of the system. See your system’s Hardware Owner’s Manual for more information on
closing the system.
10 Reconnect the power cable(s) and network cables, and then turn on the system.
Removing the PERC 5/i Adapter
NOTE:
A PERC 5/i Adapter installed on a Dell Precision workstation or PowerEdge SC server does not have a BBU.
This section describes how to remove the PERC 5/i Adapter or PERC 5/i while it is installed in a system.
1 Perform a controlled shutdown on the system in which the PERC 5/i is installed.
2 Disconnect the system from the electrical outlet, and remove the cover of the system.
CAUTION:
Running a system without the system cover installed may cause damage due to improper
cooling.
NOTE:
For more information on removing and reinstalling the system cover, see the Hardware Owner’s
Manual that shipped with the system.
connector
cable
PERC 5/i Adapter
Dell_PERC5_UG.book Page 35 Tuesday, February 13, 2007 6:02 PM