Dell Inspiron One 19 Touch (Late 2009) User Manual
Page 38
3.
Insert the memory module into the connector until the memory module snaps into position.
If you insert the memory module correctly, the securing clips snap into the cutouts at each end of the memory module.
4.
Replace the system-board shield (see
Replacing the System-Board Shield
).
5.
Replace the inverter (see
Replacing the Inverter
).
6.
Replace the I/O bracket (see
Replacing the I/O Bracket
).
7.
Replace the back cover (see
Replacing the Back Cover
).
8.
Replace the display bezel (see
Replacing the Display Bezel
).
9.
Replace the speaker cover (see
Replacing the Speaker Cover
).
10.
Replace the decorative cover (see
Replacing the Decorative Cover
).
11.
Replace the optical drive (see
Replacing the Optical Drive
).
12.
Replace the computer stand (see
Replacing the Computer Stand
).
13.
Replace the I/O cover (see
Replacing the I/O Cover
).
14.
Connect your computer and all attached devices to electrical outlets, and then turn them on.
15.
When the message appears stating that memory size has changed, press <F1> to continue.
16.
Log on to your computer.
17.
To verify that the memory is installed correctly, click Start button
®
Control Panel®
System.
18.
Check the amount of memory (RAM) listed.
Back to Contents Page
1
cutouts (2)
2
tab
3
notch
4
memory module
1
cutouts (2)
2
securing clip (snapped in position)
CAUTION:
Before turning on the computer, replace all screws and ensure that no stray screws remain inside the computer. Failure to do so may
result in damage to the computer.