Optical drive, Removing the optical drive, Replacing the optical drive – Dell Inspiron One 19 Touch (Late 2009) User Manual
Page 39
Back to Contents Page
Optical Drive
Dell™ Inspiron™ One 19 Service Manual
Removing the Optical Drive
1.
Follow the procedures in
Before You Begin
.
2.
Remove the I/O cover (see
Removing the I/O Cover
).
3.
Remove the computer stand (see
Removing the Computer Stand
).
4.
Remove the screw that secures the optical drive to the computer.
5.
Push the optical drive to release the optical drive from the optical-drive bay.
6.
Slide the optical drive out of the optical-drive bay.
Replacing the Optical Drive
1.
Follow the procedures in
Before You Begin
.
2.
Slide the optical drive into the optical-drive bay.
3.
Replace the screw that secures the optical drive to the computer.
4.
Replace the computer stand (see
Replacing the Computer Stand
).
5.
Replace the I/O cover (see
Replacing the I/O Cover
).
WARNING:
Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
CAUTION:
Only a certified service technician should perform repairs on your computer. Damage due to servicing that is not authorized by Dell™
is not covered by your warranty.
CAUTION:
To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal
surface (such as a connector on your computer).
1
screw
2
optical drive
CAUTION:
Before turning on the computer, replace all screws and ensure that no stray screws remain inside the computer. Failure to do so may
result in damage to the computer.