Dell XC Web-Scale Converged Appliance - Manual (Page 29)

29 Wyse Datacenter Appliance XC for vWorkspace
This computer is configured to receive credentials from a remote client
computer
.
3. On the SCVMM VM, enter the following from at an administrator PowerShell command prompt.
The computer names must be the FQDN of each Nutanix or Hyper-V separated by commas
along with the Microsoft Failover Cluster (MFC) name associated with the cluster:
Enable-WSManCredSSP –Role Client –DelegateComputer
Host1.domain,Host2.domain,Host3.domain,MFC_name.domain
When prompted, select Y and press Enter. Enter Get-WSManCredSSP to verify the setting. The
response should be as given here (the target names are just examples).
The machine is configured to allow delegating credentials to the
following targets: wsman/NTNX-HV-MFC.osprey.com,wsman/HV-Bensen-
03.osprey.com,wsman/HV-Bensen-02.osprey.com,wsman/HV-Bensen-
01.osprey.com,WSMAN/*
This computer is configured to receive credentials from a remote client
computer.
4. Run the brokerhelper.exe to begin the installation.
5. Click Next on the Welcome page. Accept the license and click Next.
6. Type user name and organization, and then click Next.
7. Click Install. Click Finish when completed.
8. Reboot the system.
5.4 Installing vCenter Server Appliance
NOTE: vCenter is required only when the hypervisor is vSphere.
The VMware vCenter VM will be created using the VMware vCenter Server Appliance. The VMware vCenter
Server Appliance is a preconfigured Linux-based virtual machine that is optimized for running vCenter
Server and associated services. Visit the VMware website for information on downloading version 5.5.0 and
licensing.
1. Connect to one of the Nutanix configured ESXi hosts using the VMware vSphere client.
2. In the VMware vSphere client, click File  Deploy OVF Template.