I/o panel, Removing the i/o panel, Replacing the i/o panel – Dell OptiPlex GX520 User Manual
Page 96
Back to Contents Page
Dell™ OptiPlex™ GX520 User's Guide
I/O Panel
Removing the I/O Panel
1.
Follow the procedures in "
Before You Begin
."
2.
Remove the screw that secures the I/O panel. Press on the release button and pull on the loop to slide the card away from the computer.
3.
Disconnect all of the cables from the I/O panel, and remove the panel from the computer.
Replacing the I/O Panel
1.
To replace the I/O panel, follow the removal procedure in the reverse order.
CAUTION:
Before you begin any of the procedures in this section, follow the safety instructions located in the Product Information Guide.
CAUTION:
To guard against electrical shock, always unplug your computer from the electrical outlet before removing the cover.
NOTE:
Note the routing of all cables as you remove them so that you can re-route them correctly when installing the new I/O panel.
NOTICE:
When sliding the I/O panel out of the computer, be extremely careful. Carelessness my result in damage to the cable connectors and the cable
routing clips.
1 I/O panel release button
2 securing screw
3 I/O panel
4 I/O cable connector
5 I/O cable connector pull-
loop
NOTE:
Use the guides on the I/O panel bracket to help position the I/O panel in place, and use the notch on the I/O panel bracket to help seat the
panel.