Dell Acceleration Appliances for Databases - Manual (Page 74)

To configure SNMP,
1. If you want to disable SNMP (enabled by default), clear the Enable SNMP checkbox.
2. In the Location field, enter the SNMP host or cluster name. By default, this field contains
the host or cluster name assigned in the First Boot process.
2. To specify contact information (such as an e-mail address) for the person being notified
of the SNMP traps, complete the Contact Info field.
3. To identify the SNMP community who can access the appliance, complete the
Community field. The default value is “public”.
4. In Client Address, specify the IP address, or address mask, for where the SNMP traps
should be sent.
5. To identify the SNMP community where SNMP traps will be sent, complete the Trap
Community field. The default value is “public”.
6. To specify the address where SNMP traps will be sent, enter the IPv4 address or hostname
in the Trap Address field.
To specify an additional address (up to four may be used), click the green “plus” icon to
display another entry field:
To delete an SNMP trap address, click the red trashcan icon to the right of the entry.
68