Dell Precision 620 - Manual (Page 13)

10. If it is not already connected, connect the other end of the interface cable to the appropriate connector on the system board.
11. Replace the computer cover and the front panel.
12. Reconnect your computer and peripherals to their power sources, and turn them on.
13. If the drive you just installed is the primary drive, insert a bootable diskette into diskette drive A.
14. Partition and logically format your drive before proceeding to the next step.
See the documentation for your operating system for instructions.
15. Test the hard-disk drive by running the Dell Diagnostics.
For more information, see your online system User's Guide.
16. If the drive you just installed is the primary drive, install your operating system on the hard-disk drive.
Refer to the documentation that came with your operating system.
AGP Pro Card Brace
To access any expansion cards and components on the system board, you must first remove the accelerated graphics port (AGP) Pro card brace
that secures an AGP Pro card in the AGP socket.
1. Remove the computer cover .
2. Remove the screw securing the AGP Pro card brace through the AGP Pro expansion card's mounting bracket to the back of the chassis
(see Figure 19 ).
Figure 19. AGP Pro Card Brace Removal
1 Interface cable
2 DC power input connector
3 Interface connector
4 DC power cable
CAUTION: Before you remove the computer cover, see " Precautionary Measures ."