Power supply – Dell Precision 620 User Manual
Page 18
To remove the chassis intrusion switch and install a replacement, perform the following steps:
1. Disconnect the chassis intrusion switch cable from the control panel (see
).
Note the routing of the chassis intrusion cable as you remove the cable from the chassis. The cable is routed through an enlarged hole in the
chassis and through a hole in the disk-drive cage door. The chassis intrusion switch is mounted on the left front of the chassis (see
2. Slide the chassis intrusion switch out of its slot on the chassis and carefully remove the switch and its attached cable from the chassis.
3. Install the replacement chassis intrusion switch and cable.
4. Replace the computer cover. Then reconnect your computer and peripherals to their power sources, and turn them on.
ALERT! Cover was previously removed.
5. To reset the chassis intrusion detector, enter System Setup, select System Security, and reset Chassis Intrusion to Enabled, Enabled-
Silent, or Disabled.
Power Supply
To access some components on the system board, you may have to rotate the system power supply out of the way. Use this procedure to rotate
the supply out of the chassis, or to completely remove it.
To rotate or remove the power supply, perform the following steps.
1.
2. To aid in the removal of the power supply, lay the computer on its side.
3. Disconnect the AC power cable from the AC power receptacle on the back of the power supply (see
).
1 Chassis intrusion cable connector
2 Control panel chassis intrusion connector
3 Enlarged hole for cable
4 Switch slot
5 Chassis intrusion switch
CAUTION: Before you remove the computer cover, see "
NOTE: After you remove and replace the cover, the chassis intrusion detector will cause the following message to be
displayed at the next system start-up:
NOTE: If a setup password has been assigned by someone else, contact your network administrator for information on resetting the
chassis intrusion detector.
CAUTION: Before you remove the computer cover, see "