Dell 110T DLT1 Drive - Manual (Page 10)

Getting Started and Setup: Dell PowerVault 110T DLT VS160 Tape Drive User's Guide
file:///C|/Users/rishi_sood/Desktop/Temp/MissingDocsPosted/110t_dlt/UG/setup.htm[3/8/2013 11:46:12 AM]
NOTE: Install a SCSI host adapter in the selected server now, if necessary.
NOTE: If your SCSI host adapter already has a ribbon cable with an open 68-pin, high-density connector, you can use
the existing cable instead of the cable supplied with the PowerVault 110T DLT VS160 Tape Internal drive.
4. Locate the SCSI ribbon cable in the accessories package. Attach one end of the SCSI ribbon cable to the SCSI connector
on the rear panel of the PowerVault 110T DLT VS160 Tape Internal drive. The SCSI connectors are keyed, preventing
improper connection. Use a 50- to 68-pin adapter with "high-byte termination" if the existing SCSI cable uses a 50-pin
connector.
5. Attach the other end of the SCSI ribbon cable to the SCSI host adapter. The SCSI connectors are keyed, preventing
improper connection.
6. Locate an available power cable in the host server and attach it to the power connector on the rear panel of the PowerVault
110T DLT VS160 Tape Internal drive. The connectors are keyed, preventing improper connection.
Figure 3. Attach SCSI and power cables to drive