Dell 110T DLT1 Drive - Manual (Page 15)

Getting Started and Setup: Dell PowerVault 110T DLT VS160 Tape Drive User's Guide
file:///C|/Users/rishi_sood/Desktop/Temp/MissingDocsPosted/110t_dlt/UG/setup.htm[3/8/2013 11:46:12 AM]
for information.
7. Make sure the power switch on the rear panel of the PowerVault 110T DLT VS160 Tape External drive is in the OFF
position. Attach the female connector on the power cable to the power connector on the rear panel of the drive.
CAUTION: Use caution when plugging the power cord into an electrical outlet. Hazardous voltages are present
in the sockets of the outlet.
8. Plug in the power cable to a nearby power outlet.
Figure 7. Attach terminator, SCSI, and power cables to the drive
9. Attach the power cables to the host server and all attached devices.
10. Turn on the PowerVault 110T DLT VS160 Tape External drive and any other devices you turned off earlier.
11. Turn on the host server and allow its operating system to start.
12. See
Installing the Device Drivers and Installing the Tape Backup Software to complete the installation.
Installing the Device Drivers
NOTE: The device drivers supplied on the Dell PowerVault 110T DLT VS160 Tape Drive User's Manual and Drivers CD
are required if you intend to use native operating system backup applications. Commercial backup applications generally
provide all necessary device driver support. See
Installing the Tape Backup Software for a list of compatible backup
applications.
Microsoft® Windows® 2000: