Dell Inspiron 700M - Manual (Page 87)

Appendix
87
• Basic device-configuration settings
• System security and hard-drive password settings
NOTICE:
Unless you are an expert computer user or are directed to do so by Dell technical support, do
not change the system setup settings. Certain changes might make your computer work incorrectly.
Viewing the System Setup Screens
1 Turn on (or restart) your computer.
2 When the DELL™ logo appears, press <F2> immediately. If you wait too long and the
Windows logo appears, continue to wait until you see the Windows desktop. Then shut down
your computer and try again.
System Setup Screens
NOTE:
For information about a specific item on a system setup screen, highlight the item and see the
Help area on the screen.
On each screen, the system setup options are listed at the left. To the right of each option is the setting
or value for that option. You can change settings that appear as white type on the screen. Options
or values that you cannot change (because they are determined by the computer) appear less bright.
The upper-right corner of the screen displays help information for the currently highlighted option.
System-setup key functions are listed across the bottom of the screen. The first screen of the
system setup displays the system information.
Commonly Used Options
Any changes require that you reboot the computer for new settings to take effect.
Changing the Boot Sequence
The boot sequence, or boot order, tells the computer where to look to find the software needed to
start the operating system. You can control the boot sequence and enable/disable devices using the
Boot Order page of system setup.
NOTE:
To change the boot sequence on a one-time-only basis, see "Performing a One-Time Boot" on page 88.
The Boot Order page displays a general list of the bootable devices that may be installed in your
computer, including but not limited to the following:
• USB FDD
• USB Memory
• IDE HDD
• USB HDD
• IDE CDROM
• PCI LAN