Dell 2408WFP Monitor - Manual (Page 18)

Back to Contents Page
Operating the Monitor
Dell™ 2408WFP Flat Panel Monitor User's Guide
Using the Front Panel Controls
Using the On-Scree Display (OSD) Menu
Setting the Optimal Resolution
Using the Dell Soundbar (Optional)
Using the Tilt, Swivel and Vertical Extension
Rotating the Monitor
Adjusting the Rotating Settings of Your Operating System
Using the Front Panel
Use the buttons on the front of the monitor to adjust the image settings.
A
Input Source Select
Use Input Source Select button to select between two different video signals that may be connected to your monitor.
l VGA input
l DVI-D 1 input
l DVI-D 2 input
l DisplayPort input
l HDMI input
l Component video input
l S-Video input
l Composite video input
As you cycle through the inputs you will see the following messages to indicate the currently selected input source. It may take a few
seconds for the image to appear.
If either VGA or DVI-D input is selected and both VGA and DVI-D cables are not connected, a floating dialog box as shown below appears.
If either S-Video, Composite, HDMI or Component input is selected and the cables are not connected or the video source is turned off, the
screen does not have an image. If any button is pressed (except power button), the monitor displays the following message:
or
or
or
or
or