Dell 2408WFP Monitor - Manual (Page 39)

Product Specific Problems
Universal Serial Bus (USB) Specific Problems
COMMON SYMPTOMS WHAT YOU EXPERIENCE POSSIBLE SOLUTIONS
No Video No signal indicator is displayed l Check Video Input Selection
¡ Composite: Yellow colored RCA jack
¡ S-Video: Typically a round 4 pin jack
¡ Component: Red, Blue, Green colored RCA jacks
Low Quality DVD
playback Picture not crisp and some color
distortion l Check DVD connection
¡ Composite gives good picture
¡ S-Video gives better picture
¡ Component: Red, Blue, Green colored RCA jacks
Blinking Video Video is blinking or discontinuous l Check DVD connection
¡ Composite gives good picture
¡ S-Video gives better picture
¡ Component: Red, Blue, Green colored RCA jacks
l Check if DVD player is HDCP compliant.
¡ Some non-compliant players may exhibit blinking video and others will display a
raster screen.
SPECIFIC SYMPTOMS WHAT YOU EXPERIENCE POSSIBLE SOLUTIONS
Screen image is too small Image is centered on screen, but does not fill entire
viewing area l Perform monitor reset on "Factory Reset"
Cannot adjust the monitor with
the buttons on the front panel OSD does not appear on the screen l Turn the monitor off and unplug the power
cord and then plug back and power on
The monitor will not go into
power saving mode. No picture, the LED light is green. When press "+",
"-" or "Menu" key, the message " No S-Video input
signal ", " No Composite input signal " or
" No
Component input signal " will appear.
l Move mouse or hit any key on the
keyboard on the computer or activate
video player, then access the OSD to set
Audio to " off " state.
No Input Signal when user
controls pressed No picture, the LED light is green. When press "+",
"-" or "Menu" key, the message " No S-Video input
signal ", " No Composite input signal " or " No
Component input signal " will appear. l Check the signal source Make sure the
Computer is not in power saving by moving
mouse or pressing any key on the
keyboard.
l Check to make sure Video Source to S-
Video, Composite or Component is
powered and playing video media.
l Check whether the signal cable is plugged
in and seated properly. Re
-plug the signal
cable if necessary.
l Re-boot the computer or video player.
The monitor will not fill the entire
screen. The picture can't fill the height or width of the
screen. l Due to the non-standard formats of DVDs,
the monitor may not show the full screen
pictures.
NOTE: When choosing DVI-D, DisplayPort, HDMI, S-Video, Composite or Component video, Auto Adjust function is not available.
SPECIFIC SYMPTOMS WHAT YOU EXPERIENCE POSSIBLE SOLUTIONS
USB interface is not working USB peripherals are not working l Check that your monitor is powered ON.
l Reconnect the upstream cable to your computer.
l Reconnect the USB peripherals (downstream connector).
l Switch off and then turn on the monitor again.
l Reboot the computer.
High Speed USB 2.0 interface is
slow. High Speed USB 2.0 peripherals working slowly or
not at all. l Check that your computer is USB 2.0 capable.
l Verify USB 2.0 source on your computer.
l Reconnect the upstream cable to your computer.
l Reconnect the USB peripherals (downstream connector).
l Reboot the computer.