Osd warning messages – Dell 2408WFP Monitor User Manual
Page 26
OSD Warning Messages
PIP Position
Brightness
PIP/PBP Contrast
PIP/PBP Hue/Tint
PIP/PBP Saturation
Exit Menu
Select PIP window position.
Use
and
to browse and
to select.
Adjust the brightness level of the picture in PIP/PBP Mode.
reduce the brightness
increases the brightness
Adjust the contrast level of the picture in PIP/PBP Mode.
reduce the contrast
increases the contrast
This function shifts the color of PIP/PBP image to green or purple. This is used to adjust for desired flesh tone color.
shifts image color towards green
shifts image color towards purple
Adjust the color saturation of PIP/PBP image.
makes the image look more monochrome
makes the image look more colorful
Push
to exit the OSD main menu.
When the monitor does not support a particular resolution mode you will see the following
message :
This means that the monitor cannot synchronize with the signal that it is receiving from the
computer. See
Monitor Specifications
for the Horizontal and Vertical frequency ranges addressable
by this monitor. Recommended mode is 1920 X 1200.
When monitor enters Power Save mode, the following message appears :
Activate the computer and wake up the monitor to gain access to the
If you press any button other than the power button one of the following messages will appear depending on the selected input:
VGA/DVI-D input
Video Input
or
In PIP mode, when the monitor does not sense the selected second signal input, one of the following messages will appear depending upon the selected input
as long as the OSD screen is closed.
1. VGA
2. DVI-D 1
3. DVI-D 2
4. HDMI
or
or
or
5. DisplayPort
6. S-Video
7. Composite
8. Component