Display, Removing the display assembly – Dell Inspiron Mini 10 (1010, Early 2009) User Manual
Page 16
Back to Contents Page
Display
Dell™ Inspiron™ 1010 Service Manual
Replacing the Display Assembly
Removing the Display Assembly
1.
Follow the instructions in
Before You Begin
.
2.
Remove the battery (see
Removing the Battery
).
3.
Remove the keyboard (see
Removing the Keyboard
).
4.
Remove the palm rest (see
Removing the Palm Rest
).
5.
Remove the hard drive (see
Removing the Hard Drive
).
6.
Remove the palm rest bracket (see
Removing the Palm Rest Bracket
).
7.
Disconnect the display cable from the system board connector.
8.
Disconnect the Mini-Card cables from its connectors.
9.
Make note of the Mini-Card cable routing and pull the Mini-Card cables out through the system board so that they are clear of the computer base.
10.
Remove the 3-in-1 Media Card Reader (see
Removing the Media Card Reader
).
11.
Disconnect the TV tuner cables from its connectors.
12.
Remove the two screws that secure the display assembly to the computer base.
WARNING:
Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
CAUTION:
To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal
surface.
CAUTION:
Only a certified service technician should perform repairs on your computer. Damage due to servicing that is not authorized by Dell™
is not covered by your warranty.
CAUTION:
To help prevent damage to the system board, remove the main battery (see
Removing the Battery
) before working inside the
computer.
CAUTION:
To avoid damage to the display, you must not disassemble your Edge-to-Edge display assembly in the field.
1
display cable connector
2
Mini-Card connector cables
3
TV tuner connector cables