Procedure – Dell Inspiron 23 (2350, Mid 2013) User Manual
Page 56
Advertising
56
| Removing
the
Stand
Assembly
Procedure
1
Gently peel off and release the antennas from the alignment posts on the
display bezel.
2
Press the securing clips and disconnect the LVDS cable from the display panel.
3
Disconnect the control-buttons board cable from the control-buttons board.
4
Disconnect the power-button cable from the control-buttons board cable.
5
Remove the screws that secure the cables to the display bracket.
NO
TE: Note the routing of the cables before you remove them so that you can
route them correctly after you replace the stand assembly.
1
screws (3)
2
left antenna
3
LVDS cable
4
securing clips
5
power-button cable
6
control-buttons board cable
7
alignment posts (2)
8
right antenna
3
1
8
4
5
6
7
2
book.book Page 56 Thursday, August 1, 2013 1:03 PM
Advertising