Dell 1130n Laser Mono Printer - Manual (Page 15)

Green On The machine is in power saver mode.
The machine is on-line and can receive data from the computer.
Blinking When the LED blinks slowly, the machine is receiving data from the computer.
When the LED blinks rapidly , the machine is printing data.
Red On The cover is open. Close the cover.
There is no paper in the tray. Load paper in the tray.
The machine has stopped due to a major error.
Your system has some problems. If this problem occurs, contact your service
representative.
The toner cartridge has almost reached its estimated cartridge life [ a ] . It is
recommended to replace the toner cartridge. (See Replacing the toner
cartridge .)
Blinking A minor error has occurred and the machine is waiting for the error to be
cleared. When the problem is cleared, the machine resumes.
Toner is low. Replace the cartridge. The estimated cartridge life
[ a ]
of toner is
close. Prepare a new cartridge for replacement. You may temporarily increase
the printing quality by redistributing the toner. (See
Redistributing toner .)
[ a ] Estimated cartridge life means the expected or estimated toner cartridge life, which indicates the average
capacity of print-outs and is designed pursuant to ISO/IEC 19752. The number of pages may be affected by
operating environment, printing interval, media type, and media size. Some amount of toner may remain in the
cartridge even when red LED turned on and the printer stops printing.
Dell does not recommend using non-genuine Dell toner cartridge such as refilled or re-manufactured. Dell
cannot guarantee non-genuine Dell toner cartridge's quality. Service or repair required as a result of using non-
genuine Dell toner cartridges will not be covered under the machine warranty.
All printing errors will be appear in the Printer Status Monitor program window. If the problem persists, call for
service.
Buttons
(Cancel button)
By pressing the (cancel button), you can:
Function Description
Printing
demo
page
[ a ]
In Ready mode, press and hold this button for about 2 seconds until the status LED blinks slowly,
and release. (See
Printing a demo page .)
Printing
configuration
sheet
[ b ]
In Ready mode, press and hold this button for about 5 seconds until the status LED blinks fast, and
release. (See
Printing a machine report .)
Printing a
cleaning
sheet
[ b ]
In Ready mode, press and hold this button for about 10 seconds until the status LED blinks slowly,
and release. (See
Cleaning the inside .)
Cancel print
job Press (cancel button) during printing. The red LED blinks while the print job is cleared from both
the machine and the computer and then the machine returns to ready mode. This may take some
time depending on the size of the print job.
Manual print Press (cancel button) each time you load a sheet of paper in the
manual tray when you select Manual Feeder for Source from your software application.
[ a ]
When you print the demo page for Dell 1130, configuration sheet is printed as well.
[ b ]
Dell 1130n only
(Power button)
This button must be used to turn the machine on/off.
Turning on the machine
1. Plug in the power cord.
2. Press (power) on the control panel.