Installing network connected, Machine’s driver, Installing network connected machine’s driver – Dell 1130n Laser Mono Printer User Manual
Page 28: Network parameter setting, Restoring factory default settings, Windows
MAC Address : Find the machine’s MAC address from the Network Configuration Report and enter it
without the colons. For example, 00:15:99:29:51:A8 becomes 0015992951A8.
IP Address: Enter a new IP address for your printer.
For example, if your computer’s IP address is 192.168.1.150, enter 192.168.1.X. (X is number between 1
and 254 other than the computer’s address.)
Subnet Mask: Enter a Subnet Mask.
Default Gateway: Enter a Default Gateway.
6.
Click Apply, and then click OK. The machine will automatically print the Network Configuration Report.
Confirm that all the settings are correct.
7.
Click Exit to close the SetIP program.
8.
If necessary, restart the computer’s firewall.
Network parameter setting
You can also set up the various network settings through the network administration programs such as Embedded
Web Service.
Restoring factory default settings
You may need to reset the machine to the factory default settings when machine that you are using is connected to
new network environment.
Restoring factory default settings using Embedded Web Service
1.
Start a web browser and enter your machine’s new IP address in the browser window.
For example,
2.
When the Embedded Web Service window opens, click Network Settings.
3.
Click Reset. Then, click Clear for network.
4.
Turn off and restart machine to apply settings.
Installing network connected machine’s driver
Windows
You can set up the machine driver, follow the steps below.
This is recommended for most users. All components necessary for machine operations will be installed.
1.
Make sure that the machine is connected to the network and powered on.
2.
Insert the supplied software CD into your CD/DVD drive.
The software CD should automatically run and an installation window appear.
If the installation window does not appear, click Start and then Run. Type X:\Setup.exe, replacing “X”
with the letter which represents your drive. Click OK.
If you use Windows Vista, Windows 7 and Windows 2008 Server R2 click Start > All programs >
Accessories > Run.