Dell 1130n Laser Mono Printer User Manual
Page 76
Paper is jammed. Clear the paper jam. (See
.)
No paper is loaded. Load paper. (See
The toner cartridge is not installed. Install the toner cartridge.
If a system error occurs, contact your service representative.
The connection cable
between the computer
and the machine is not
connected properly.
Disconnect the machine cable and reconnect it.
The connection cable
between the computer
and the machine is
defective.
If possible, attach the cable to another computer that is
working properly and print a job. You can also try using a
different machine cable.
The port setting is
incorrect.
Check the Windows printer setting to make sure that the
print job is sent to the correct port. If the computer has
more than one port, make sure that the machine is attached
to the correct one.
The machine may be
configured incorrectly.
Check the Printing Preferences to ensure that all of the
print settings are correct. (See
The printer driver may be
incorrectly installed.
Repair the machine software. (See
Installing network connected machine’s
The machine is
malfunctioning.
Check the LEDs on the control panel to see if the machine
is indicating a system error. Contact a service
representative.
Checking an error message is also possible from the
Printer Status Monitor on your computer.
The machine does not
print.
The document size is so
big that the hard disk
space of the computer is
insufficient to access the
print job.
Get more hard disk space and print the document again.
The output tray is full.
It can hold up to 80 sheets of plain paper. Once the paper is
removed from the output tray, the machine resumes printing.
The machine selects
print materials from the
wrong paper source.
The paper option that
was selected in the
Printing Preferences
may be incorrect.
For many software applications, the paper source selection is
found under the Paper tab within the Printing Preferences.
Select the correct paper source. See the printer driver help
screen. (See
.)
A print job is extremely
slow.
The job may be very
complex.
Reduce the complexity of the page or try adjusting the print
quality settings.
Half the page is blank.
The page orientation
setting may be incorrect.
Change the page orientation in your application. See the
printer driver help screen.
The paper size and the
paper size settings do not
match.
Ensure that the paper size in the printer driver settings
matches the paper in the tray.Or, ensure that the paper size
in the printer driver settings matches the paper selection in
the software application settings you use.
The machine prints, but
the text is wrong,
garbled, or incomplete.
The machine cable is
loose or defective.
Disconnect the machine cable and reconnect. Try a print job
that you have already printed successfully. If possible, attach
the cable and the machine to another computer that you
know works and try a print job. Finally, try a new machine
cable.
The wrong printer driver
was selected.
Check the application’s printer selection menu to ensure that
your machine is selected.
The software application
is malfunctioning.
Try printing a job from another application.
The operating system is
malfunctioning.
Exit Windows and reboot the computer. Turn the machine off
and back on again.
If you are in a DOS
environment, the font
setting for your machine
may be set incorrectly.
Changing font setting (Dell 1130n only)
.