Figure 7-9, Attaching diskette drive or tape drive cables -8 – Dell OptiPlex E1 User Manual
Page 112
7-8
Dell OptiPlex E1 Mini Tower Managed PC Reference and Installation Guide
&$87,21 :KHQ \RX FRQQHFW WKH FDEOH LQ WKH QH[W VWHS \RX PXVW PDWFK WKH
FRORUHG VWULS RQ WKH FDEOH ZLWK SLQ RQ WKH GULYH·V LQWHUIDFH FRQQHFWRU WR
DYRLG SRVVLEOH GDPDJH WR \RXU V\VWHP
&RQQHFW WKH DSSURSULDWH LQWHUIDFH FDEOH WR WKH LQWHUIDFH FRQQHFWRU RQ
WKH EDFN RI WKH GULYH VHH )LJXUH
If your system came with an EIDE CD-ROM or tape drive, use the spare connec-
tor on the existing interface cable. Otherwise, use the EIDE interface cable
provided in the drive kit.
)LJXUH $WWDFKLQJ 'LVNHWWH 'ULYH RU 7DSH 'ULYH &DEOHV
)RU DQ (,'( WDSH GULYH RU &'520 GULYH FRQQHFW WKH RWKHU HQG RI WKH
LQWHUIDFH FDEOH WR WKH LQWHUIDFH FRQQHFWRU ODEHOHG ´,'(µ RQ WKH V\VWHP
ERDUG
For a diskette drive or non-EIDE tape drive, connect the cable from the drive to
the interface connector labeled “DSKT” on the system board.
For a drive that comes with its own controller card, connect the other end of the
interface cable to the controller card.
Check all cable connections. Fold cables out of the way to provide airflow for the
fan and cooling vents.
,I WKH LQFK GULYH ED\ ZDV SUHYLRXVO\ HPSW\ UHPRYH WKH IURQWSDQHO
LQVHUW IURP WKH IURQW EH]HO
See “Removing and Replacing Front-Panel Inserts” found earlier in this chapter.
diskette/tape drive
interface cable
DC power cable
interface connector
power input connector