Dell OptiPlex E1 - Manual (Page 81)

Working Inside Your Computer 5-5
)LJXUH  &RPSXWHU 2ULHQWDWLRQ 9LHZ
Figure 5-5 shows your computer with its cover removed. Refer to this illustration to
locate interior features and components discussed in this guide.
When you look inside your computer, note the DC power cables coming from the
power supply. These cables supply power to the system board; to internal diskette
drives, hard-disk drives, and tape drives; and to certain expansion cards that connect
to external peripherals.
The flat ribbon cable in Figure 5-5 is typical of the interface cables for internal drives.
An interface cable connects a drive to a connector on the system board or on an
expansion card.
The system board—the large printed circuit board at the bottom of the chassis—holds
the computer’s control circuitry and other electronic components. Some hardware
options are installed directly onto the system board.
During an installation procedure, you may be required to change a jumper setting on
the system board and/or a jumper or switch setting on an expansion card or on a drive.
Jumpers and switches provide a convenient and reversible way of reconfiguring the
circuitry on a printed circuit board. For information on jumpers and switches, see the
following two subsections.
-XPSHUV
Jumpers are small blocks on a circuit board with two or more pins emerging from
them. Plastic plugs containing a wire fit down over the pins. The wire connects the
pins and creates a circuit.
front back
drive
cage
power
supply
internal
drive bracket
expansion-card
cage
top
system
board
bottom