Dell OptiPlex E1 - Manual (Page 96)

6-6 Dell OptiPlex E1 Mini Tower Managed PC Reference and Installation Guide
 *UDVS WKH FDUG E\ LWV RXWVLGH FRUQHUV DQG VOLGH LW RXW RI LWV FRQQHFWRU
 ,I \RX DUH UHPRYLQJ WKH FDUG SHUPDQHQWO\ LQVWDOO D PHWDO ILOOHU EUDFNHW
RYHU WKH HPSW\ FDUGVORW RSHQLQJ
NOTE: Installing filler brackets over empty card-slot openings is necessary to
maintain Federal Communications Commission (FCC) certification of the system.
The brackets also keep dust and dirt out of your computer.
 5HSODFH WKH H[SDQVLRQFDUG FDJH LQ WKH FKDVVLV DV LQVWUXFWHG LQ
´5HSODFLQJ WKH ([SDQVLRQ&DUG &DJHµ LQ &KDSWHU 
 5HSODFH WKH FRPSXWHU FRYHU UHFRQQHFW \RXU FRPSXWHU DQG SHULSKHUDOV
WR WKHLU HOHFWULFDO RXWOHWV DQG WXUQ WKHP RQ
NOTE: After you remove and replace the cover, the chassis intrusion detector will
cause the following message to be displayed at the next system start-up:
ALERT! Cover was previously removed.
 7R UHVHW WKH FKDVVLV LQWUXVLRQ GHWHFWRU HQWHU WKH 6\VWHP 6HWXS SURJUDP
DQG UHVHW &KDVVLV ,QWUXVLRQ WR 1RW 'HWHFWHG
See Chapter 2, “Using the System Setup Program,” for instructions.
NOTE: If a setup password has been assigned by someone else, contact your
network administrator for information on resetting the chassis intrusion detector.
$GGLQJ0HPRU\
Memory can be increased to a maximum of 256 megabytes (MB) by installing combi-
nations of 16-, 32-, 64-, or 128-MB nonparity synchronous dynamic random-access
memory (SDRAM) dual in-line memory modules (DIMMs) in the two DIMM sockets
on the system board. Figure 6-6 shows the DIMMs and DIMM sockets. DIMM speed
(66 megahertz [MHz]) should match the external bus speed of the microprocessor.
)LJXUH  ',00V DQG ',00 6RFNHWV
DIMMs (2)
DIMM sockets (2)