Dell OptiPlex E1 - Manual (Page 113)

Installing Drives 7-9
 5HSODFH WKH IURQW EH]HO
 5HSODFH WKH FRPSXWHU FRYHU UHFRQQHFW \RXU FRPSXWHU DQG SHULSKHUDOV
WR WKHLU SRZHU VRXUFHV DQG WXUQ WKHP RQ
 8SGDWH \RXU V\VWHP FRQILJXUDWLRQ LQIRUPDWLRQ
For a diskette drive, enter the System Setup program and update the appropriate
Diskette Drive option (A or B) on the System Setup screen to reflect the size and
capacity of your new diskette drive. (For more information, see Chapter 2, “Using
the System Setup Program.”)
If you installed a non-EIDE tape drive as the second drive, set the Diskette
Drive B option to Not Installed.
For EIDE CD-ROM and tape drives, set the appropriate Drive option (0 or 1)
under Drives: Secondary to Auto.
 9HULI\ WKDW \RXU V\VWHP ZRUNV FRUUHFWO\
See your Diagnostics and Troubleshooting Guide for information on running the
Dell Diagnostics and troubleshooting any problems that may occur. Use the fol-
lowing guidelines to determine which test to use:
‡
If you installed a diskette drive, test it by running all of the subtests in the
Diskette Drive(s) Test Group of the Dell Diagnostics.
‡
If you installed a CD-ROM drive, see the documentation that came with the
drive for instructions on loading device drivers and using the drive. If it is an
EIDE CD-ROM drive, test it by running all of the subtests in the IDE CD-ROM
Drives Test Group of the Dell Diagnostics.
‡
If you installed a tape drive, first verify that your diskette drive is still operat-
ing correctly by running all of the subtests in the Diskette Drive(s) Test Group
of the Dell Diagnostics. Then perform a tape backup and verification test
with the drive as instructed in the tape-drive software documentation that
came with the tape drive.
NOTE: Tape drives sold by Dell come with their own operating software and doc-
umentation. After you install a tape drive, refer to the documentation that came
with the drive for instructions on installing and using the tape drive software.
,QVWDOOLQJDQ(,'(+DUG'LVN'ULYH
This section includes information on installing, partitioning, and formatting EIDE hard-
disk drives.
Up to two EIDE drives (one of which must be 1 inch high or less) can be installed in
the hard-disk drive bracket below the drive cage. The first EIDE drive is installed in the
1-inch (lower) drive bay labeled “HD1”; a second drive is installed in the 1.6-inch bay
labeled “HD2.”