Dell Inspiron 640M - Manual (Page 167)

Appendix
167
3 Turn on the computer. When the DELL logo appears, press <F2> immediately. If you wait too long
and the Windows logo appears, continue to wait until you see the Windows desktop. Then shut down
your computer and try again.
4 When the boot device list appears, highlight the device from which you want to boot and press
<Enter>.
The computer boots to the selected device.
The next time you reboot the computer, the previous boot order is restored.
Cleaning Your Computer
CAUTION:
Before you begin any of the procedures in this section, follow the safety instructions located in the
Product Information Guide.
Computer, Keyboard, and Display
CAUTION:
Before you clean your computer, disconnect the computer from the electrical outlet and remove any
installed batteries. Clean your computer with a soft cloth dampened with water. Do not use liquid or aerosol
cleaners, which may contain flammable substances.
• Use a can of compressed air to remove dust from between the keys on the keyboard and to remove any
dirt or lint from the display.
NOTICE:
To help prevent damage to the computer or display, do not spray cleaning solution directly onto the
display. Only use products specifically designed for cleaning displays, and follow the instructions that are included
with the product.
• Moisten a soft, lint-free cloth with either water or a display cleaner. Do not use alcohol or an ammonia-
based cleaner. Wipe the display gently working from the center to the edges until it is clean and any
fingerprints are removed. Do not use excessive pressure.
• Moisten a soft, lint-free cloth with water and wipe the computer and keyboard. Do not allow water
from the cloth to seep between the touch pad and the surrounding palm rest.
Touch Pad
1 Shut down and turn off your computer. See "Turning Off Your Computer" on page 109.
2 Disconnect any attached devices from the computer and from their electrical outlets.
3 Remove any installed batteries. See "Using a Battery" on page 37.
4 Moisten a soft, lint-free cloth with water, and wipe it gently across the surface of the touch pad. Do not
allow water from the cloth to seep between the touch pad and the surrounding palm rest.