Dell Dimension 3100C - Manual (Page 81)

Removing and Installing Parts
81
Installing a Media Card Reader
CAUTION:
Before you begin any of the procedures in this section, follow the safety instructions located in the
Product Information Guide.
NOTICE:
To prevent static damage to components inside your computer, discharge static electricity from your
body before you touch any of your computer’s electronic components. You can do so by touching an unpainted
metal surface on the computer chassis.
1 Follow the procedures in "Before You Begin" on page 53.
2 Remove the drive panel (see page 70).
3 Remove the Media Card Reader and bracket from its packaging.
4 Insert three shoulder screws into the sides of the Media Card Reader and tighten them.
5 Gently slide the drive (which should not yet be connected to the FlexBay cable) into place until you
hear a click or feel the drive securely installed.
6 Connect the USB cable on the back of the Media Card Reader to the front panel USB connector on
the system board (see page 61).
7 Connect the FlexBay USB cable to the back of the Media Card Reader.
8 Replace the computer cover (see page 84).
DVD Drive
CAUTION:
Before you begin any of the procedures in this section, follow the safety instructions located in the
Product Information Guide.
CAUTION:
To guard against electrical shock, always unplug your computer from the electrical outlet before
removing the cover.