Dell KVM 2161DS - Manual (Page 146)

130 Managing Your Remote Console Switch Using the On-board Web Interface
3 In the PDU settings box, change the PDU name, set the cycle delay time,
enable or disable the current protection, enable or disable the audible
alarm and set the minimum amps and maximum amps in the Inlet
Parameters field.
To configure a device connected to a PDU:
1 Click the Configure tab in the on-board web interface, then click the
PDUs category in the left column for a list of PDUs.
2 Click on the PDU you wish to access. The PDU Settings window opens.
3 Click the Outlet Settings button at the bottom of the PDU Settings
window for a list of devices connected to the PDU. The Outlet Settings
window opens.
4 To modify an outlet name, complete the following steps:
a In the Name column, click on the link for the outlet you wish to
change. The Modify Power Outlet Name window opens.
b If the device is a server, click Server, then select the name by clicking
on the appropriate entry in the Server Name column of the table
-or-
If the device is not a server, click
Other Device, then enter the
appropriate text in the Name text box.
c Click Save, then click Close to return to the Outlet Settings window.
5 To modify the power-on interval, enter the value in seconds in the text box
in the Power-On Interval column for the outlet being configured.
6 Click Save, then click Close to return to the PDUs window.
To power-control a device connected to a PDU:
1 Click the Configure tab in the on-board web interface, then click the
Outlets subcategory located under PDUs in the left column for a list of
available outlets.
NOTE: An outlet only appears in this list if a name has been associated with it.
2 Check the box next to the outlet(s) you wish to configure.
3 Click the On button to turn on the selected outlet(s).
- or -
Click the
Off button to turn off the selected outlet(s).