Dell KVM 2161DS - Manual (Page 60)

44 Controlling Your System at the Analog Ports
1 Click in the New text box.
2 Type the new password in the New text box. Passwords must contain both
alpha and numeric characters, are case sensitive, and may be up to 12
characters long. Legal characters are: A to Z, a to z, 0 to 9, and hyphen.
3 In the Repeat box, type the password again.
4 Click OK to change only your password, and then close the dialog box.
To password protect your console:
1 Set your password as described in the previous procedure.
2 Select Enable Screen Saver.
3 Type the number of minutes for Inactivity Time (from 1 to 99) to delay
activation of password protection and the screen saver feature.
4 For Mode, select Energy if your monitor is E
NERGY
S
TAR®
compliant;
otherwise select Screen.
CAUTION: Monitor damage can result from the use of Energy mode with
monitors not compliant with Energy Star®.
5 (Optional) Click Test to activate the screen saver test, which lasts 10
seconds then returns you to the Security dialog box.
6 Click OK.
To log in to your console:
1 Press any key or move the mouse.
2 The Password dialog box displays. Type your password, then click OK.
3 The Main dialog box displays if the password was entered properly.
To remove password protection from your console:
1 From the Main dialog box, click Setup - Security.
2 In the Security dialog box, click in the New box. Leave the box blank. Press
<Enter>.
3 Click in the Repeat box. Leave the box blank.
4 Click OK to eliminate your password.
To enable the screen saver mode with no password protection: