Dell Latitude Xpi CD - Manual (Page 73)

Running the Dell Diagnostics 4-3
H
ow to Use the Dell Diagnostics
When you select RUN ALL TESTS or RUN SPECIFIC TESTS
from the Diagnostics Menu, the main screen of the diagnostics
appears (see Figure 4-2). The main screen lists the diagnostic test
groups, gives information about the configuration of the com-
puter, and allows you to select options from a menu.
To select an option from the Diagnostics Menu, highlight
the option and press <
ENTER >, or press the key that corre-
sponds to the highlighted letter in the option.
Information on the main screen of the diagnostics is pre-
sented in the following five areas:
• Two lines at the top of the screen identify the
diagnostics and give its version number.
• On the left side of the screen, the Available Test
Groups area lists the diagnostic test groups in the
order they will be run if you select the
RUN menu
option and then the ALL menu option. Press the up- or
down-arrow key to highlight a test group.
• On the right side of the screen, the System Configu-
ration area lists the computer’s current hardware
settings.
• On the lower-right side of the screen, the IDE Drive
Information area displays information about your
hard-disk drive.
Two lines at the bottom of the screen make up the menu
area. The first line lists the options you can select; press
the left- or right-arrow key to highlight a menu option.
The second line gives information about the option cur-
rently highlighted.
CAUTION: While the diagnostic tests are running,
do not interrupt the tests, do not unplug the AC
adapter, and do not reboot the computer. Inter-
rupting the tests in any of these ways could lead to
the loss of system data. It is important to quit the
diagnostic program correctly because the program
writes data to the computer’s memory that can
cause problems unless properly cleared.