Dell Dimension 3000 - Manual (Page 56)

56
Removing and Installing Parts
9 Align the notch on the bottom of the module with the crossbar in the connector.
NOTICE:
To avoid breaking the memory module, do not press near the middle of the module.
10 Insert the module straight down into the connector, ensuring that it fits into the vertical guides at each
end of the connector. Press firmly on the ends of the module until it snaps into place.
If you insert the module correctly, the securing clips snap into the cutouts at each end of the module.
11 Replace the computer cover (see page 75).
NOTICE:
To connect a network cable, first plug the cable into the network wall jack and then plug it into the
computer.
12 Connect your computer and devices to electrical outlets, and then turn them on.
13 Click the Start button, right-click My Computer, and then click Properties.
14 Click the General tab.
15 To verify that the memory is installed correctly, check the amount of memory (RAM) listed.
Cards
CAUTION:
Before you begin any of the procedures in this section, follow the safety instructions located in the
Product Information Guide.
notch
memory module
cutouts (2)
crossbar