Dell Dimension 3000 - Manual (Page 72)

72
Removing and Installing Parts
2 Remove two extra alignment screws, shown in the illustration on page 72, from the front of the
computer and insert them into the drive.
NOTE:
Some computers come with only two extra alignment screws; others come with four. You only need two
alignment screws for this procedure.
3 Gently slide the drive into place in the drive bay.
4 After the drive is in place, apply pressure to ensure that the drive is fully seated.
5 Use the securing screw that came with the drive to attach the drive to the computer.
drive
alignment screws (2)
drive
alignment screws (2)
securing
screw
extra alignment
screws (2 or 4)