Dell Dimension 3000 - Manual (Page 86)

86
Appendix
4 At the bottom of the menu, enter the number of the device that is to be used for the current boot only.
For example, if you are booting to a USB memory key, highlight USB Flash Device and press
<Enter>.
NOTE:
To boot to a USB device, the device must be bootable. To make sure that your device is bootable, check the
device documentation.
Changing Boot Sequence for Future Boots
1 Enter system setup (see page 80).
2 Use the arrow keys to highlight the Boot Sequence menu option and press <Enter> to access the
menu.
NOTE:
Write down your current boot sequence in case you want to restore it.
3 Press the up- and down-arrow keys to move through the list of devices.
4 Press the spacebar to enable or disable a device (enabled devices have a checkmark).
5 Press plus (+) or minus (–) to move a selected device up or down the list.
Clearing Forgotten Passwords
CAUTION:
Before you begin any of the procedures in this section, follow the safety instructions located in the
Product Information Guide.
1 Follow the procedures in "Before You Begin" on page 45.
PSWRD