Dell POWEREDGE M1000E - Manual (Page 16)

Software User’s Manual Rev 1.00
16
Description:
Use this command to restart the module components. When this command is issued, PTM compo-
nents go through a full hardware reset, followed by software reload.
Options:
• device_number: specify a single device to reset
Example:
$ reload
3.5 Software Update Commands
3.5.1 show image ver
Synopsys:
show image ver
Description:
Display the current software image version.
ADMIN: This command also displays the firmware version of each component.
Example:
# login admin
& show image ver
Software image short version: V Z.ZZ
Software image version: X.X.XXX-<date stamp>
Component #1 firmware version: Y.Y.YYY
Component #2 firmware version: Y.Y.YYY
Component #3 firmware version: Y.Y.YYY
& login user
3.5.2 copy image from-file
Synopsys:
copy image from-file [device_number]
Description:
Update the firmware the PTM software image. In ADMIN mode, it allows selective upgrade of a
single device in the PTM. Immediately after running this command, the CLI waits for the user to
send the firmware image using the ZModem protocol. To abort this operation, use CTRL-C. For
additional details on the firmware update procedure refer to
Section 4, “Operating Procedures,”
on page 22 .
ADMIN: