Dell PowerVault LTO3-080 - Manual (Page 31)

Step 2 — Connecting Power
An external Dell PowerVault Tape Drive will operate using any voltage in the range 100–240 volts (50–60 Hz). No adjustment is needed. To connect your drive
to the power supply, proceed as follows:
1. Plug the power cable securely into the socket on the rear panel of the drive.
2. Plug the other end of the power cable into a grounded power outlet.
3. Power on the tape drive by pressing the power on/off button. The tape drive runs the POST, which checks all hardware except the drive head.
Step 3 — Connecting the SAS Cable
Attach one end of the SAS cable to the SAS host adapter card installed in the system. Attach the other end of the SAS cable to the SAS connector on the rear
panel of the tape drive. The cable can be up to 5 m (16.4 ft) long. This configuration is shown in Figure 11.
Figure 11. Connecting One SAS Device
1. System
2. SAS host adapter card
3. SAS cable
4. Drive SAS connector
5. Tape drive
To connect a second system to the tape drive, attach one end of the second SAS cable to the SAS host adaptor installed in the second system. Attach the
other end of the second SAS cable to the other SAS port on the rear panel of the tape drive. This configuration is shown in Figure 12, "Connecting two SAS
Devices."