Dell PowerEdge 1600SC - Manual (Page 81)

8. Connect a DC power cable connector to the drive's power input connector (see Figure 7 -3 ).
9. Connect the interface cable to the drive (see Figure 7 -3 ) and to the system board or controller card:
l Figure 7 -4 illustrates a common cable configuration for externally accessible IDE drives.
l Figure 7 -5 illustrates a SCSI tape drive connected to the SCSI controller on the system board.
l Figure 7 -6 shows a SCSI tape drive connected to a SCSI controller card.
If necessary, temporarily remove the baffle to allow easier routing of the interface cable (see " Removing the Baffle " in "Troubleshooting Your
System").
For information about the controller card, see the documentation that accompanied the card.
Figure 7-4. Connecting an IDE CD Drive and Optional IDE Tape Drive to the Integrated IDE Controller
Figure 7-5. Connecting an SCSI Tape Drive to the Integrated SCSI Controller