Microprocessor, Installation guidelines, Upgrading the microprocessor(s) – Dell PRECISION 530 User Manual
Page 107
107
Microprocessor
• Installation guidelines
• Upgrading the microprocessor(s)
Installation Guidelines
•
A VRM must be installed for each microprocessor installed. To locate
the VRM and microprocessor sockets, see "
•
For single-processor operations, the processor must be installed in
socket 0 and the VRM must be installed in connector 0. Processor
socket 1 and VRM connector 1 must be empty. To locate these
components, see "
•
For dual-processor operations, both processor sockets and both VRM
connectors must be populated.
•
For dual-processor operations, the two processors and the two VRMs
must be identical. If the processors do not match, you receive a
computer message, the diagnostic lights indicate an error, and the
computer does not start. If the VRMs do not match, the diagnostic
lights indicate an error.
•
If installing a Dell processor upgrade kit for either single or dual
processors, remove and discard the original VRM(s). Then install the
VRM(s) from the upgrade kit. If you are not installing a processor
upgrade kit from Dell, reuse the original VRM(s).
•
If you are upgrading your microprocessor, keep your original
microprocessor heat sink and securing clips for future trouble
shooting.
NOTICE:
Dell recommends that you use only microprocessors purchased from
Dell. Microprocessors purchased elsewhere are not guaranteed to work with
Dell computers.
Upgrading the Microprocessor(s)
NOTE:
Dell recommends that only a technically knowledgeable person
perform this procedure.
CAUTION:
The processor can get very hot during normal
operation. Be sure that the processor has had sufficient time to
cool before you touch it.