Dell S510 Interactive Projector - Manual (Page 43)

Using Your Projector 43
2 Saturation, Sharpness, and Tint only available when the input source
is from Composite.
I MAGE S ETTINGS (N O I NPUT S OURCE )— Select and press to activate
image settings. The image settings menu provides the following options:
VGA O UTPUT —Select On or Off the VGA output function at projector
standby status. Default is Off.
D ISPLAY S ETTINGS ( IN PC M ODE )— Select and press to activate display
settings. The display settings menu provides the following options:
H ORIZONTAL P OSITION —Press to move the image right and to
move the image left.
V ERTICAL P OSITION —Press to move the image up and to move
the image down.
F REQUENCY —Allows you to change the display data clock frequency to
match the frequency of your computer’s graphics card. If you see a
vertical flickering wave, use the Frequency control to minimize the
bars. This is a coarse adjustment.
T RACKING —Synchronize the phase of the display signal with the
graphic card. If you experience an unstable or flickering image, use
Tracking to correct it. This is a fine adjustment.