Dell XPS 400/Dimension 9150 - Manual (Page 80)

80
Removing and Installing Parts
www
.dell.com | support.dell.com
10 Close the card retention door by snapping it into place to secure the card(s).
NOTICE:
Do not route card cables over or behind the cards. Cables routed over the cards can prevent
the computer cover from closing properly or cause damage to the equipment.
11 Connect any cables that should be attached to the card.
See the documentation for the card for information about the card cable connections.
NOTICE:
To connect a network cable, first plug the cable into the network device and then plug the
cable into the computer.
12 If you replaced a card that was already installed in the computer and you removed the
retention mechanism, you may reinstall the retention mechanism.
13 Before replacing the card retention mechanism, ensure that:
• The tops of all cards and filler brackets are flush with the alignment bar.
• The notch in the top of the card or filler bracket fits around the alignment guide.
14 Snap the card retention mechanism into place, securing the x16 PCI card.
15 Replace the computer cover, reconnect the computer and devices to electrical outlets, and
then turn them on.
16 If you installed a sound card:
a Enter system setup, select Integrated Audio Controller, and then change the setting
to Off.
b Connect external audio devices to the sound card connectors. Do not connect external
audio devices to the microphone, speaker/headphone, or line-in connectors on the back
panel.
17 If you installed an add-in network adapter and want to disable the integrated network
adapter:
a Enter system setup, select Integrated NIC Controller, and then change the setting
to Off.
b Connect the network cable to the add-in network adapter connectors. Do not connect
the network cable to the integrated connector on the back panel.
18 Install any drivers required for the card as described in the card documentation.
Removing a PCI Card
1 Follow the procedures in "Before You Begin" on page 63.
2 Remove the computer cover (see page 68).
3 If you are removing the card permanently, install a filler bracket in the empty card-slot
opening.
If you need a filler bracket, contact Dell (see page 126).
WD741bk2.book Page 80 Thursday, July 20, 2006 10:44 AM