Display: dell latitude 100l service manual, Display, Display assembly – Dell Latitude 100L User Manual
Page 23
Display: Dell Latitude 100L Service Manual
file:///C|/Work%20Area%20-%20A/E%20DOC%20Posting/latc100l/en/Service%20Manual/display.htm[2/4/2013 3:01:03 PM]
Display
Dell™ Latitude™ 100L Service Manual
Display Assembly
CAUTION:
Before performing the following procedures, read the safety instructions in your System
Information Guide.
CAUTION:
To prevent static damage to components inside your computer, discharge static electricity from
your body before you touch any of your computer's electronic components. You can do so by touching an
unpainted metal surface.
1. Follow the instructions in "
Before Working Inside Your Computer
2. Remove the
.
3. Remove the
4. Remove the
5. Remove the
.
6. Close the display.
7. From the back of the computer, remove the two M2.5 x 5-mm screws.
8. Open the display assembly approximately 180 degrees, and support the display assembly so that it does not open past
this position.
9. Pull straight up on the pull-tab that is attached to the display-feed flex cable to disconnect the cable from the system
board.
10. Remove the two M2.5 x 5-mm screws from each hinge bracket.