Display panel, Removing the display panel – Dell Latitude 100L User Manual
Page 26
Display: Dell Latitude 100L Service Manual
file:///C|/Work%20Area%20-%20A/E%20DOC%20Posting/latc100l/en/Service%20Manual/display.htm[2/4/2013 3:01:03 PM]
3. Remove the
4. Use a plastic scribe to pry the two screw covers and three display bumpers out of the screw holes located on the front
of the bezel.
5. Remove the five M2.5 x 5-mm screws located on the front of the bezel.
NOTICE:
Carefully separate the bezel from the top cover to avoid damage to the bezel.
6. Starting at the bottom of the display panel, use your fingers to separate the bezel from the top cover and lift the inside
edge of the bezel away from the top cover.
Display Panel
Removing the Display Panel
CAUTION:
Before performing the following procedures, read the safety instructions in your System
Information Guide.
CAUTION:
To prevent static damage to components inside your computer, discharge static electricity from
your body before you touch any of your computer's electronic components. You can do so by touching an
unpainted metal surface.
1. Follow the instructions in "
Before Working Inside Your Computer
2. Remove the
3. Remove the
4. Remove the
.
5. Remove the two M2 x 3-mm screws on the each side of the display panel.
6. Lift the display panel out of the top cover.
7. Press in both sides of the top flex-cable connector, and pull the top flex-cable connector away from the display
connector.