Dell Latitude 100L User Manual
Page 33
Microprocessor Thermal-Cooling Assembly: Dell Latitude 100L Service Manual
file:///C|/Work%20Area%20-%20A/E%20DOC%20Posting/latc100l/en/Service%20Manual/thermal.htm[2/4/2013 3:01:05 PM]
1 captive screws (4)
2 fan power-cable connector
6. Pull up the microprocessor thermal-cooling assembly by the pull-tab to lift the assembly out of the system board.
Installing the Microprocessor Thermal-Cooling Assembly
NOTICE:
Before you install the replacement microprocessor thermal-cooling assembly, remove the mylar that covers
the thermal grease on the assembly.
1. If you are installing a replacement microprocessor thermal-cooling assembly, remove the mylar that covers the thermal
grease on the assembly. If you are installing the assembly that you removed in the previous section:
a. Wipe the thermal grease off of the microprocessor thermal-cooling assembly with a clean paper towel.
b. Squeeze all of the contents of the thermal grease packet (provided with the kit) on to the microprocessor
thermal-cooling assembly.
2. Place the back of the microprocessor thermal-cooling assembly under the palm rest, and lower the assembly onto the
system board.
3. Connect the fan power cable to the system board.
4. Tighten the four captive screws, labeled "1" through "4," in consecutive order.
.
.