Dell XPS 430 (Mid 2008) - Manual (Page 46)

System Setup: Dell XPS 430 Service Manual
setup.htm[4/15/2014 11:28:36 AM]
eSATA
(On default)
Enables or disables eSATA.
Off — eSATA is disabled.
On — eSATA is enabled.
NOTE: eSATA is not supported in ATA
mode.
SATA Operation
(RAID On default)
Enables or disables RAID (for more
information, see the Dell Technology
Guide).
RAID Autodetect/ATA — RAID if
signed drives, otherwise ATA.
RAID On — SATA is configured for
RAID on every boot.
Onboard Devices
Integrated NIC
(On default)
Enables or disables the integrated network
interface controller (NIC).
Off — The integrated NIC is
disabled.
On — The integrated NIC is
enabled.
On w/PXE — The integrated NIC is
on (with PXE enabled).
NOTE: PXE is required only if you are
booting to an operating system located
on another computer. If a boot routine is
not available from the remote system,
the computer attempts to boot from the
next device listed in the boot sequence.
Integrated Audio
(Auto default)
Enables or disables the onboard audio
controller.
Off — Integrated audio is disabled.
On — Integrated audio is enabled.
Auto — If installed, the add-in
audio controller is enabled.
USB Controller
(On default)
Enables or disables the internal USB
controller. Set to On (default) so that
USB devices will be detected and
supported in the operating system.
Off — The USB controller is
disabled.
On — The USB controller is
enabled.
No Boot — The USB controller is
enabled; however, the BIOS will
not recognize USB storage devices.
NOTE: Operating systems with USB
support will recognize USB storage
devices regardless of the No Boot
setting.
Rear Tri USB
(On default)
Enables or disables the indicated group of
USB ports.
Off — The USB group is disabled.