Configuring the network with a dhcp server – Dell UPS 1920T User Manual
Page 16
16
|
Getting Started
Configuring the Network With a DHCP Server
The card automatically collects the IP parameters from the server by default.
NOTE:
When the card is not connected to the network, it continuously attempts to connect. When the
connection is established, the LEDs indicate the status (see Table 1 on page 10).
To view the parameters:
1
From the main menu, type 2 and press Enter. The Network Settings menu displays (see Figure 9).
-------------------------------------------------------------
Network settings
-------------------------------------------------------------
1 : Read Network settings
2 : Modify Network settings
3 : Set Ethernet speed
0 : Exit
-------------------------------------------------------------
Figure 9. Network Settings Menu
2
Type 1 and press Enter. The card displays the settings supplied by the server (see Figure 10).
-------------------------------------------------------------
Network configuration
-------------------------------------------------------------
MAC address : 00:22:19:FF:8E:13
Mode : DHCP
IP address : 166.99.224.48
Subnet mask : 255.255.255.0
Gateway : 166.99.224.1
Link Local IPv6 address : FE80::222:19FF:FEFF:8E13 /64
Global IPv6 address : 2001:720:410:100A:222:19FF:FEFF:8E13 /64
Global IPv6 address : 1789:720:410:100A:222:19FF:FFF:8E13 /64
-------------------------------------------------------------
Figure 10. Network Configuration Menu