Dell 6 GBps SAS HBA - Manual (Page 20)

20 Driver Installation
NOTE: Use a formatted USB key to provide the driver. For additional details
check the Dell Support website at support.dell.com .
4 Insert the driver media in the media drive and press <Enter>.
A list of SAS controllers is displayed.
5 Select the appropriate driver for the installed controller and press
<Enter> to load the driver.
NOTE: If the version of the driver you provide does not match the version on
your system a message may be displayed. To use the driver on the media,
press <S>.
6 Press <Enter> to continue the installation process as usual.
Installing the Driver During a Windows Server 2008 or Windows Server
2008 R2
1 Boot the system using the Windows Server 2008 or the Windows Server
2008 R2 media.
2 Follow the on-screen instructions until the following message is displayed:
Where do you want to install 2008;
3 Select Load driver...
The system prompts for the media to be inserted. Insert the installation
media and browse to the proper location when prompted.
4 When prompted, select the appropriate card from the list, click Next and
continue installation as usual.